- Product Description
-
DESCRIPTION
Everbuild Silicone Eater is specifically designed to remove all silicone based sealants and surface water repellents - cured and uncured. The product acts by denaturing silicone polymers making them easily water or solvent rinsable.
FEATURES AND BENEFITS
- Readily denatures silicone.
- Ready for use gel - may be used vertically as well as horizontally.
- Water clean-up.
USES
- May be used on aluminum* and its alloys, copper and its alloys, iron, steels, glass, ceramics, epoxy composites, most plastics.
- Has little effect on rubber and other elastomers.
- Has little effect on most painted surfaces.
APPLICATION INFORMATION
- Boiling point - 205°C
- Solubility - Insoluble in water
- pH - 3 in 100g/ltr water
- Flash Point - ~70°C
SUBSTRATE PREPARATION
All surfaces must be clean, dry and dust free. Cut away as much as possible of the silicone sealant using a sharp knife. Protect surrounding areas with impervious masking tape
LIMITATIONS
- *TEST A SMALL AREA BEFORE USE. In all cases, apply a small test patch to an inconspicuous area. Leave for 2 hours min and rinse off. Check for staining/corrosion before attempting the whole job.
- * May attack nylon, certain fabrics/textiles and coloured anodised aluminum (used as a trim around showers), PU coated (re-enameled) baths, fluoroacrylics, chipped surfaces.
Product Downloads