A ready-to-use, clear sealant for block paving, paths and driveways

Key Features

• Protects from water penetration; staining and dirt/grime build-up.
• Advanced "Hybrid" technology.
• Ready to use.
• Excellent abrasion and chemical resistance.
• Inhibits organic growth.
• Solvent free.

Uses

Designed to protect from water penetration, oil or grease spillages and dirt/grime build-up. Will enhance present colour and extend the lifespan of the treated surface.

Application Information

DRIVE ALIVE CLEAR COAT BLOCK SEALER is ready to use, and does not require diluting. We advise that you test this product on a small inconspicuous area prior to use to check compatibility. STIR WELL BEFORE USE. Ensure that the surface is completely dry. Apply a single coat using either a brush, roller or squeegee, ensuring no pooling or ponding occurs. Allow 3-4 hours drying time before trafficking the area. Application temperature between 5ºC and 30ºC. Colder humid conditions will slow drying times.

Substrate Preparation

Remove any moss or lichen that may be present. Ensure the surface to be treated is free from oil, grease, dust and any other loose material that may hinder adhesion. It is recommended that a test be carried out on a small inconspicuous area to ensure the required effect is achieved.

Limitations

Do not apply to wet or damp surfaces or in conditions of high humidity. Surfaces should be allowed to dry completely for 48 hours prior to application. Do not use if rain is imminent (protect from rain until dry). Do not apply to non-porous surfaces. Keep children and animals away and do not traffic until fully cured. Do not allow any run off to contaminate drains, waterways or plants. Do not use in temperatures below +5° C and above +30° C.