DESCRIPTION

Everbuild 206 Strike Release Oil is a high quality chemical release agent to enable concrete shuttering to be removed easily, leaving the edge of the concrete structure clean and well formed. It is a solvent and mineral oil free emulsion based on biological degradable synthetic oil and is recommended for spray, brush or roller application to moulds manufactured from wood, metal, polypropylene, ABS, polyurethane and other plastics which are susceptible to long term damage by conventional release agents. Produces a high quality stain and blemish free concrete finish with minimum incidence of blowholes.

FEATURES AND BENEFITS

• Excellent ‘sticking’ ability on vertical mould surfaces 
• No need to dilute 
• Self-levelling after spray application
• Non-combustible vapour 
• Reduced ‘dusty’ residues on the formwork 
• Safe to handle
• Easy and precise separation of the formwork from the hardened concrete 
• High quality surface finish Protection of formwork from steel corrosion and early ageing

USES

• As a release agent for smooth non-absorbent formwork, absorbent formwork, heated formwork (up to 70°C) and textured formwork.

APPLICATION INFORMATION

• Yield - 50-60 m2/litre for steel and plastic
•             40-50 m2/litre for coated plywood
•             20-30 m2/litre for untreated timber

SUBSTRATE PREPARATION

All formwork should be clean and dry before application, with any residues of rust or concrete removed. Stir thoroughly before application. Apply undiluted by spray, brush or roller ensuring a thin and even coverage. Care should be taken to avoid over application which can result in dusting of the concrete surface. Any excess material in the bottom of the moulds should be mopped up prior to the placement of the concrete. For new and unsealed timbers or other highly absorbent formwork, pre-treatment is recommended with a second coat prior to use. After application, an evaporation period of 20 minutes (at +20°C) should be observed prior to casting.

LIMITATIONS

• Only apply a thin film. Overdosing can cause dusting.