DESCRIPTION

Roll and Stroll Hard Surface Protector is the ultimate self adhesive hard surface protector, ideal for protecting against mess, dirt, staining, spillages and soiling that occurs during painting, plastering, building, tiling, general maintenance and repair work. Totally waterproof, it protects against expensive to clean paint spillages on hard surfaces. Due to the adhesive face being reverse wound, it easily unwinds with minimum effort and no need to bend down.

FEATURES AND BENEFITS

• Easy roll out with no specialist applicator equipment required.
• Will not creep and wrinkle after application. Stays where it is put!
• Totally waterproof. Protects against expensive to clean spillages from paints, varnishes etc. 
• Easily removed, will not leave a sticky residue. 
• Can be left for up to 4 weeks .
• Adheres to most common hard surfaces.
• Safer than dust sheets.

USES

• Ideal for protecting most hard surfaces including timber, ceramic tiles, laminate, vinyl, metal and stone.
• Can also be used to protect worktops, window sills, doors, kitchen units and glass.

APPLICATION INFORMATION

• Ensure surfaces to which it is to be applied are clean sound, dust free and dry. Remove outer packaging from roll. Place roll on the floor facing the direction it is to be applied and unwind approx 12 inches (300mm) of material. Ensure the roll is stuck by smoothing out by either hand or foot. Simply push roll forward using hands or feet ensuring roll goes in a straight line. Smooth out with hands or feet as it unwinds. A very effective way of laying Roll and Stroll Hard Surface Protector is to push the roll along with a soft broom/brush using the brush to smooth out and remove air bubbles as it unwinds. For application to worktops, glass etc roll and smooth out by hand until required length is reached. Carefully cut Roll and Stroll Hard Surface Protector with a sharp knife or scissors, take care not to damage or scratch the covered surface.

LIMITATIONS

• This product is for application to hard surfaces, DO NOT use on carpets. Use Roll and Stroll Carpet Protector. 
• Adhesion will be reduced on dusty surfaces. Vacuuming or mopping prior to use is recommended.
• It must be removed after a maximum of 4 weeks to prevent a sticky residue being left.
• Always check the Roll and Stroll Hard Surface Protector is stuck firmly to surfaces before commencing work.
• On some surfaces it may leave a residue, this can be easily removed using Everbuild Wonder Wipes or hard surface cleaner. A test area is always recommended prior to full application. Please note when cleaning laminate flooring do not use excess water.
• Always check compatibility of cleaning agent with sub floor prior to full application. 
• In heavily trafficked areas or where air temperature exceeds 22°C, remove it after 1 week maximum. Do not use underfloor heating whilst product is in situ. 
• Do not use on surfaces which bleed oils or plasticizers.
• Product may become slippery when wet. Mop up any spills immediately or replace it where necessary.
• It is the users responsibility to determine suitability for use. If in doubt contact technical services for advice