DESCRIPTION

Everbuild Lumberjack Wood Preserver is a solvent free, low odour solution based on Micro-fine active technology. The fungicides and algaecides present in this formulation are finely dispersed so that wood penetration and hence effectiveness is much greater than standard wood preservation products. In addition the use of ultra-lightfast pigments on the coloured variants give an even, fade-resistant finish which will last for years. It is fast-drying and non-flammable; and application to wet timbers is possible without loss of performance. It is specifically designed to deeply penetrate all wood and joinery to give long-lasting protection from damage caused by wet rot, dry rot, decay and fungi.

FEATURES AND BENEFITS

• Free from fungicide and solvent - will not harm fish.
• Fast cure - gives quick early strengths.
• Extremely low dirt pick up.
• Waterproof seal - will withstand continuous water immersion.

USES

• For use on interior or exterior rough-sawn or planed timber such as floorboards, joists, roof timbers, window frames and doors

APPLICATION INFORMATION

• Dosage - 1 litre will treat 3 – 4 square metres.

SUBSTRATE PREPARATION

Shake well before use. Apply by brush, spray or dipping. Apply a minimum of two coats if brushing or spraying. The second coat should be applied after the first coat has soaked in but before it is dry. Pay particular attention to thoroughly soaking the end grain. Where possible, and for maximum protection, dip the end grains of the timber for a minimum of 3 minutes.

LIMITATIONS

• Ready to use - do not dilute.
• Always use coarse rather than fine mist generators.
• Do not apply to surfaces on which food is prepared.
• Avoid contact with bitumen, roofing felt or plastics.
• It is the user’s responsibility to determine suitability for use. If in doubt, contact Technical Services Department for advice.