DESCRIPTION

Rustins Quick Dry Red Oxide Metal Primer is a low odour high performance paint containing anti-corrosive additives for use on both bare and galvanised metal that is suitable for indoor and outdoor use.

PREPARATION

For use on bare metal, the surface must be clean, free from rust and grease. Remove existing finishes with Rustins Strypit Paint and Varnish Stripper. If the metal is rusty, remove loose rust with a wire brush or scraper, then treat with Rustins Rust Remover.

APPLICATION

• Stir well before use. Do not thin the product.
• Apply liberally by brush.
• One coat is sufficient but two coats will provide improve durability.
• Do not apply below 10°C. High humidity and cold conditions will significantly extend the drying times. Do not use below 10°C, in damp conditions or if rain is imminent.

RE-COATING TIME

The primer will be touch dry in approximately 30 minutes depending on temperature and humidity and can be re-coated with a further coat of primer or top coat after a minimum of two hours.

COVERAGE

1 litre will cover approximately 10 square metres per litre per coat depending on the absorbency and texture of the surface being treated.

CLEANING

Remove as much paint as possible and return to this container. Brushes should the be cleaned immediately with water. If the brushes become hard, they may be cleaned with Rustins Brush Restorer or Rustins Cellulous Thinners.