DESCRIPTION

A multi-purpose, rubber based construction adhesive in mild solvents, that can replace mechanical fixings in a wide variety of domestic, commercial and industrial applications. SAVES NAILS is a fast bonding adhesive with gapfilling properties to bridge gaps up to 12mm. It can be used in all weather conditions and is suitable for rough and porous surfaces. It has good low temperature resistance for freezers and cold applications. This product is toluene free.

USES

• Bond It SAVES NAILS is ideal for fixing a wide variety of materials to all types of walls and suitable for insulating PU foams. It can also be used to fix skirting boards, door surrounds and frames, window sills, all types of cladding, wall battens, decorative wall boards, metal carpet edges, automotive trims and much more. It can be used for interior and exterior applications.
• SAVES NAILS is ideal for use on:
• Brick
• Some plastics
• Timber
• Marble Stone
• Brick veneer
• Concrete
• Metal
• Ceramic

APPLICATION INFORMATION

• Application Apply using a standard sealant gun with the nozzle cut at an angle of 45°, and to an opening slightly larger than the joint to be sealed. Apply a 6mm bead (or thicker to suit gap) in a zig zag along one length of the item to be fixed. Press into place and apply an even pressure on the entire surface, leave to cure for 48 hours. Temporary support or fixings are recommended on very heavy items whilst curing.
• Bracing or additional mechanical fastening is recommended for ceiling or heavy wall panels while the adhesive develops full strength. When bonding foam to ceiling additional mechanical fastenings are to be used. Excessive material can be removed using white spirit or cellulose thinners. Clean tools immediately after use.

SUBSTRATE PREPARATION

• Ensure all surfaces are clean, dry and free from grease or any contaminants that may hinder adhesion

LIMITATIONS

• Not suitable for areas subject to frequent water immersion.
• Not recommended for use on asphalt, bitumen or polystyrene.
• Not to be used as a mirror adhesive. 
• Dusty or porous surfaces should be primed with a primer prior to application - consult our technical department for details.